Vendor: Formula
Formula Brake Hose Full Length (Light E-Moto)
This part = 48 entries to win the ETM RTR
Description
If your brake lever feels spongy, your hose is swelling under heat, or you clipped a rock and nicked the line on your last trail ride, this is the fix. The Formula Brake Hose Full Length is a genuine Formula replacement brake line built for the demands of light electric motos — not some generic hydraulic line from a hardware store. At 200cm uncut, it gives you plenty of length to route front or rear on virtually any e-moto frame, and you simply trim to fit with a clean square cut before bleeding.
Formula engineered this hose with a reinforced Kevlar-weave inner layer that resists expansion under pressure, which means you get a firmer lever feel and more consistent bite point compared to worn or aftermarket lines. The fittings are Formula-spec banjo ends, so they thread directly into your Formula master cylinder and caliper without adapters. If you're upgrading from a budget brake system or replacing a damaged OEM line, this is the part that restores factory-level brake confidence.
Compatible With:
- Surron Light Bee X
- Surron Ultra Bee
- Talaria Sting MX3 / MX4 / MX5
- E-Ride Pro SS / SR
- Any light e-moto running Formula-spec hydraulic brakes
Features:
- 200cm full-length hose — cut to your exact routing length
- Kevlar-reinforced inner weave for minimal line expansion under braking pressure
- Genuine Formula construction — not a third-party knockoff
- Formula-spec banjo fittings for direct master cylinder and caliper compatibility
- DOT 4 / mineral oil compatible (match your existing brake fluid)
- UV and abrasion-resistant outer jacket for trail durability
- Works for front or rear brake line replacement
Whether you're doing a full brake overhaul or just swapping a sketchy line before your next ride day, this hose gets you back to full stopping power with zero compromise. Ready to ship from the USA, straight to your door.
See Also: Formula Brake Caliper | Formula Brake Bleed Kit | Brake Accessories
Frequently Asked Questions
Do I need to bleed my brakes after installing this hose?
Yes. Any time you open the hydraulic system you'll introduce air. Grab a Formula Brake Bleed Kit and fresh fluid, and bleed the system after install for a firm, consistent lever.
What tool do I use to cut the hose to length?
A sharp hydraulic hose cutter or a clean razor blade works best. You want a perfectly square cut so the olive and insert seat properly in the banjo fitting. Avoid side-cutters or wire snips — they crush the hose and cause leaks.
Will this work on a non-Formula brake setup?
This hose is designed for Formula-spec fittings. If your bike runs Shimano, Magura, or another brand, the banjo ends won't thread correctly. Stick with a hose matched to your caliper and master cylinder brand.
Bike fitment
Check fitment before you send it.