79 Bike suspension hardware kit by Prickly — complete rebuild fastener set

Prickly Motorsports

79 Bike Suspension Hardware Kit

$15.00

This part = 15 entries to win the ETM RTR

Fits 1 bikes — see the list
  • 79Bike
Ships fast from Idaho Falls
Double-check fitment before you send it — hit the fitment tab below.
Description

The Prickly 79 Bike Suspension Hardware Kit replaces the worn, stripped, or missing fasteners in your 79Bike Falcon's rear suspension and linkage. Trail abuse, repeated teardowns, and corrosion all take a toll on stock suspension hardware, and a single rounded bolt or loose pivot can turn a quick fix into a much bigger repair. This direct-fit kit gets every linkage and shock-mount fastener back to spec so your rear end moves the way it should — controlled, quiet, and predictable lap after lap.

Compatible With:

  • 79Bike Falcon Pro
  • 79Bike Falcon

Features:

  • Direct-fit replacement hardware for the 79Bike rear suspension and linkage
  • High-strength fasteners that resist bending and rounding under hard trail loads
  • Corrosion-resistant finish built to shrug off mud, water, and grit
  • Restores correct bolt preload and bearing spacing for consistent suspension feel
  • OEM-spec sizing for a no-guesswork, bolt-in fit
  • Installs with common metric tools — no fabrication or special pullers required
  • Cheap insurance against play that accelerates bearing and bushing wear

Keep your 79Bike's suspension tight, quiet, and dialed in for the next ride. Ships fast from the USA, straight to your door.

See Also: Warp 9 Titanium Fork Bolts | EXT Arma MX Rear Shock | Suspension Accessories

Frequently Asked Questions

Will this hardware fit my 79Bike Falcon Pro?

Yes. This kit is sized to directly replace the factory rear suspension and linkage hardware on the 79Bike Falcon and Falcon Pro with no modification needed.

What does replacing my suspension hardware actually improve?

Fresh, correctly-torqued hardware removes play in the linkage and shock mounts, which sharpens rear-end feel, kills clunks, and helps prevent accelerated bearing wear.

Do I need special tools to install it?

No. A standard set of metric hex/Torx tools and a torque wrench is all you need to swap the hardware in your own garage.

Bike fitment
  • 79Bike
79 Bike Suspension Hardware Kit $15.00