The stock headlight on a Surron or Talaria is fine for riding home before dark. It is not fine for actually seeing anything once the sun drops. The beam is dim, the pattern is narrow, and on anything rougher than a gravel road you're riding on hope more than light. Swapping it out is one of the highest-value upgrades you can make to a build, and it's a bolt-on job you can knock out in a driveway in under half an hour.
Why Your Stock Headlight Isn't Enough
Stock e-bike and light electric motorcycle headlights are built for legal compliance, not trail visibility. They throw a low-lumen, unfocused beam that works for being seen on a street but leaves you guessing on anything unlit — fire roads, trailheads, or the ride home after a late session. A proper LED kit changes that completely: more usable lumens, a real beam pattern (flood for close-in trail detail, spot for distance), and housings built for vibration instead of a daily commute.
Choosing the Right Baja Designs Kit for Your Build
We run Baja Designs on every Throttle Co demo bike because they build for powersports, not bicycles, and it shows in beam quality and housing durability. If you want maximum output and don't mind the larger housing, the Squadron Pro Headlight Kit is the top of the lineup — serious lumens, a tight and predictable beam pattern, and the same housing Baja puts on full-size dual-sport bikes. If you want something closer to stock dimensions with a cleaner factory look, the S2 Pro Headlight Kit gives you nearly the same output in a smaller package. Riding mostly pavement and tighter singletrack where a wider, shorter-throw beam matters more than long-distance punch? The S2 Sport Headlight Kit is the budget-friendly option that still massively outperforms stock.
Tools and Time You'll Need
Every kit ships with the mounting hardware and wiring harness, so this is a true bolt-on — no splicing, no soldering, no trip to the hardware store. Set aside about 30 minutes and grab a basic metric hex key set (most mounts use M4-M6 bolts), a zip-tie pack for routing the harness cleanly along the fork and frame, and a small flathead or trim tool if your model's headlight shroud clips in rather than bolts on. That's it. No crimping tools, no electrical tape, no guesswork.
Step-by-Step Installation
Start by disconnecting your battery or main power switch before touching any wiring — always work on a dead circuit. Remove the stock headlight by backing out its mounting bolts or releasing the shroud clips, then unplug its factory connector. Mount the new Baja Designs housing to the stock mounting point using the hardware included in the kit; most Surron and Talaria mounts line up directly with Baja's bracket without drilling. Route the wiring harness along the existing factory harness path, zip-tying it every few inches so nothing can snag on the fork during travel. Connect the new harness to your bike's factory headlight connector — it's a direct plug-in on nearly every current Surron and Talaria model, no pin modification needed. Reconnect your battery, aim the beam level with the bike sitting level on flat ground, and snug down every bolt you touched.
After the Install: Dialing In Your Beam
Aim matters more than most riders think. Point the beam too high and you'll blind oncoming riders without lighting your own path; too low and you're wasting half your lumens on the dirt six feet in front of your wheel. Stand the bike on level ground, sit on it (your weight changes suspension sag and therefore aim), and adjust the housing until the brightest part of the beam lands around 50-75 feet ahead for trail riding, closer for tight technical sections. Give the mounting bolts a re-torque after your first ride — vibration will find any bolt you didn't snug all the way down.
Once it's installed, you'll wonder how you rode without it. Browse the full lineup of Baja Designs headlight kits we stock, or hit us up if you're not sure which kit fits your specific model — we've installed enough of these to talk you through it in under a minute.